Sales: 512-635-8793
Customer Service: 512-635-8824
Fax: 512-650-3663
FREE Ground Shipping on most orders over $50*

Dfuser Blueprinted Front Wheel Hub (NA/NB Chassis)



Our Price: $192.99

Model: HUB404-1 / DFR-1001044
Shipping Weight: 4lbs
Manufactured by: Dfuser



Add to Cart:


Dfuser Blueprinted Front Wheel Hub (NA/NB Chassis)

If you're running your NA or NB Miata hard on the track, you're probably burning through front wheel bearings on a regular basis. And that means you're losing track time or races. ART knows this, so they've put together these blueprinted hubs. They start off as factory hubs, but they're carefully checked and packed with a high temperature grease. They'll cut down your failure rate dramatically.

Sure, they're a bit more expensive. But they'll last a whole lot longer than stock ones, so you'll save money in the long run.

Available either with stock studs or with strong extended ARP units. If you go for the ARP units, you will need to press them into the hubs.

If you have ABS, you'll have to transfer your ABS ring over to the new hubs. Sold individually. Nuts and Cap are not included, but are highly recommended.

Recommended installation is to have everything very clean, install and torque to 125 ft-lbs. After a couple of hours of running, re-torque to 150 ft-lbs.

Only HUB and standard studs pictured are included.

Reference: (NA01-33-04X) OR HUB404-1



Customers who bought this product also purchased...



Copyright © 2018 CrazyMonkeyRaceProducts.com, LLC. Powered by Zen Cart